In this video I will walk you through exactly how I built this Heat Exchange Recirculating Mash (HERMS) System. I am very excited to bring this to youtube and apologize for how long it has been since part 1 Sanding and Polishing Stainless Steel Keg to a Mirror Finish [4K] https://youtu.be/NFvBxo4DJoY was published. I’ll walk you through how I cut the top off the keg, Installed fittings, put together all of the fittings, and a final installation. I also have a neat bottom mash drain specifically for kegs. Part 3 should be out soon stay tuned and thanks for the support!!
UNDER NO CIRCUMSTANCES WILL TREV’S GARAGE BE RESPONSIBLE OR LIABLE IN ANY WAY FOR ANY CONTENT, INCLUDING BUT NOT LIMITED TO, ANY ERRORS OR OMISSIONS IN THE CONTENT, OR FOR ANY LOSS OR DAMAGE OF ANY KIND INCURRED AS A RESULT OF ANY CONTENT COMMUNICATED ON THIS YOUTUBE PAGE, WHETHER BY TREV’S GARAGE OR A THIRD-PARTY. IN NO EVENT SHALL TREV’S GARAGE BE LIABLE FOR ANY SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS ARISING OUT OF OR IN CONNECTION WITH THE AVAILABILITY, USE OR PERFORMANCE OF ANY INFORMATION COMMUNICATED ON THIS YOUTUBE PAGE.